Difference between revisions of "Talk:Virtual Ethernet device"
(unsigned comment by andrex) |
|||
| Line 8: | Line 8: | ||
being run on the host node, VE0. I don't think this can be correct, because eth0 exists in VE 101, not VE0. | being run on the host node, VE0. I don't think this can be correct, because eth0 exists in VE 101, not VE0. | ||
-- {{unsigned|Andrex}} | -- {{unsigned|Andrex}} | ||
| + | |||
| + | |||
| + | : This is correct, because we need to enable forwarding on both network interfaces in VE0 (host-node eth0 and veth101.0) to allow the network packets on one network interface (host-node eth0) to be forwarded to another network interface (veth101.0). The same thing with proxy ARP, we need to enable it on host-node eth0 and veth101.0 network interfaces. --[[User:Major|Major]] 08:42, 17 July 2006 (EDT) | ||
Revision as of 12:42, 17 July 2006
Under Common Configurations -> Simple configuration -> Configure devices in VE0, the example shows
[host-node]# echo 1 > /proc/sys/net/ipv4/conf/eth0/forwarding [host-node]# echo 1 > /proc/sys/net/ipv4/conf/eth0/proxy_arp
being run on the host node, VE0. I don't think this can be correct, because eth0 exists in VE 101, not VE0. -- —The preceding unsigned comment was added by Andrex (talk • contribs) .
- This is correct, because we need to enable forwarding on both network interfaces in VE0 (host-node eth0 and veth101.0) to allow the network packets on one network interface (host-node eth0) to be forwarded to another network interface (veth101.0). The same thing with proxy ARP, we need to enable it on host-node eth0 and veth101.0 network interfaces. --Major 08:42, 17 July 2006 (EDT)
