Bridge doesn't forward packets

Sometimes a bridge can mysteriously drop packets and not forward them. e.g. eyck user experienced a problem when some of the broadcasts were not delivered to container via the bridge.

Original report and the thread: forum thread

Contents

Simplest configuration

Container #101 with veth interface (veth101.0) connected to eth0 physical interface via bridge.

Problem statement

We faced a situation when some of the broadcast packets were not delivered to the container. Actually it could happen with any packets, not with the broadcasts only. But broadcasts are simpler and obviously should have been delivered to all the networking interfaces with no doubt.

Using tcpdump we see that BOOTP/DHCP request is visible on br0 interface in the host system (CT0):

 15:21:52.258220 00:1b:d5:2c:bf:38 > ff:ff:ff:ff:ff:ff, ethertype IPv4 (0x0800), length 350: 0.0.0.0.68 > 255.255.255.255.67:
   BOOTP/DHCP, Request from 00:1b:d5:2c:bf:38, length 308
 15:21:52.287269 00:08:02:ac:36:20 > ff:ff:ff:ff:ff:ff, ethertype IPv4 (0x0800), length 342: 172.17.8.254.67 > 255.255.255.255.68:
   BOOTP/DHCP, Reply, length 300

However, eth0 inside the container received only 2nd packet with a BOOTP/DHCP reply and doesn't see the 1st one with the request itself:

 15:21:52.291145 00:08:02:ac:36:20 > ff:ff:ff:ff:ff:ff, ethertype IPv4 (0x0800), length 342: 172.17.8.254.67 > 255.255.255.255.68:
   BOOTP/DHCP, Reply, length 300

Resolution

It is not obvious at all, but bridges (though they have their own ebtables filters) do also call iptables FORWARD chain when forwarding packets between interfaces. Thus your FORWARD iptables rules should allow all the packets which are supposed to go through.

in our case eyck had a default DROP policy on FORWARD and had to add:

 iptables -A FORWARD -d 255.255.255.255 -j ACCEPT

to fix the issue.

Another Problem Case

I had setup a bridge andgot the same problem, but iptables was setup well. In my case the problem was lying in /proc/sys/net/bridge/

everything inside had value "1", changed them to "0" and problem was solved.

Credits

Many credits to Dariush Pietrzak, who patiently helped to debug this.