Difference between revisions of "Docker inside CT vz7"

From OpenVZ Virtuozzo Containers Wiki
Jump to: navigation, search
m
m
Line 1: Line 1:
 
Since Virtuozzo 7 kernel vzkernel-3.10.0-327.18.2.vz7.14.7 it is possible to run Docker inside containers. This article describes how.
 
Since Virtuozzo 7 kernel vzkernel-3.10.0-327.18.2.vz7.14.7 it is possible to run Docker inside containers. This article describes how.
<br>'''This page is applicable for Virtuozzo 7.'''
+
<br>'''This page is applicable for Virtuozzo 7''' (for OpenVZ 6 see [[Docker inside CT | '''here''']]).
  
 
== Prerequisites ==
 
== Prerequisites ==
Line 24: Line 24:
 
* Only '''overlay''' and '''vfs''' Docker graph drivers are currently supported
 
* Only '''overlay''' and '''vfs''' Docker graph drivers are currently supported
 
* [[Checkpointing and live migration]] of a container with Docker containers inside is not supported yet (to be done)
 
* [[Checkpointing and live migration]] of a container with Docker containers inside is not supported yet (to be done)
 
== See also ==
 
* [[Docker inside CT]] page for running Docker Containers inside OpenVZ 6 Containers
 
  
 
[[Category:HOWTO]]
 
[[Category:HOWTO]]
 
[[Category: TRD]]
 
[[Category: TRD]]

Revision as of 20:49, 18 July 2016

Since Virtuozzo 7 kernel vzkernel-3.10.0-327.18.2.vz7.14.7 it is possible to run Docker inside containers. This article describes how.
This page is applicable for Virtuozzo 7 (for OpenVZ 6 see here).

Prerequisites

  • Kernel 3.10.0-327.18.2.vz7.14.7 or later version
  • Kernel modules veth and overlay loaded on host

Note: if you use kernel >= 3.10.0-327.18.2.vz7.14.25, you need to allow using "overlayfs" inside a Virtuozzo Container:

echo 1 > /proc/sys/fs/experimental_fs_enable

Container tuning

  • Turn on bridge feature to allow docker creating bridged network:
vzctl set $veid --features bridge:on --save
  • Setup Container veth-based network (Container must be veth-based, not venet-based):
vzctl set $veid --netif_add eth0 --save
  • Allow all iptables modules to be used in containers:
vzctl set $veid --netfilter full --save


Limitations

  • Only overlay and vfs Docker graph drivers are currently supported
  • Checkpointing and live migration of a container with Docker containers inside is not supported yet (to be done)