Open main menu

OpenVZ Virtuozzo Containers Wiki β

FUSE

Revision as of 15:31, 17 November 2006 by Kir (talk | contribs) (added ext. links)

This page describes how to setup FUSE (filesystem in userspace) inside a VE.

FUSE is a filesystem in which data and metadata are provided by an ordinary userspace process. The filesystem can be accessed normally through the kernel interface.

Contents

Preparations

To use FUSE you need the following:

  1. OpenVZ kernel version 028test005 or higher
  2. Fuse lib
  3. Any FUSE-based filesystem

In the examples below sshfs is used.

Setup

Kernel

Download appropriate kernel from openvz.org or compile kernel with CONFIG_FUSE_FS option set

Libfuse

Compile libfuse in a VE without kernel module

# vzctl enter 100
# tar xzf fuse-2.6.0.tar.gz
# cd fuse-2.6.0
# ./configure --disable-kernel-module
...
# make
...
# make install
  Note: Sometimes libfuse.so.X is unseen by your programs. Usually this file is installed in /usr/local/lib directory so don't forget to add it into your /etc/ld.so.conf

Filesystem

Download and compile filesystem.

# vzctl enter 100
# tar xzf sshfs-fuse-1.7.tar.gz
# cd sshfs-fuse-1.7
# ./configure
...
# make
...
# make install

VE tuning

You need to make a characted device named /dev/fuse and grant your VE permissions to it

# vzctl set 100 --devices c:10:229:rw --save
...
# vzctl exec 100 mknod /dev/fuse c 10 229
...

Mounting filesystem

After this you may try to mount FUSE in a VE

# vzctl enter 100
# sshfs root@foo.org:/root /mnt/foo.org.root

Unmounting filesystem

In case of sshfs after umounting an appropriate daemon must be killed. This may be done by the following command:

# fusermount -u moutpoint

Using fusectl filesystem

Fusectl is a helper filesystem for FUSE. You may mount it in a VE as well

# vzctl enter 100
# mount -t fusectl none /fuse_ctl

External links