Editing Using private IPs for Hardware Nodes
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 103: | Line 103: | ||
==== Set up a bridge on a HN ==== | ==== Set up a bridge on a HN ==== | ||
− | This can be done by configuring | + | This can be done by configuring <code>ifcfg-*</code> files located in <code>/etc/sysconfig/network-scripts/</code>. |
Assuming you had a configuration file (e.g. <code>ifcfg-eth0</code>) like: | Assuming you had a configuration file (e.g. <code>ifcfg-eth0</code>) like: | ||
Line 114: | Line 114: | ||
</pre> | </pre> | ||
− | To | + | To make bridge <code>br0</code> automatically created you can create <code>ifcfg-br0</code>: |
<pre> | <pre> | ||
DEVICE=br0 | DEVICE=br0 | ||
Line 124: | Line 124: | ||
</pre> | </pre> | ||
− | and edit <code>ifcfg-eth0</code> to add | + | and edit <code>ifcfg-eth0</code> file to add <code>eth0</code> interface into the bridge <code>br0</code>: |
<pre> | <pre> | ||
DEVICE=eth0 | DEVICE=eth0 |