Difference between revisions of "VPN via the TUN/TAP device"

From OpenVZ Virtuozzo Containers Wiki
Jump to: navigation, search
(add notes about autoload tun module)
Line 15: Line 15:
 
</pre>
 
</pre>
  
You can also add it into /etc/modules.conf to make sure it will be loaded on every reboot automatically. (On RHEL create a script /etc/sysconfig/modules/tun.modules).
+
To make sure that '''tun''' module will be automatically loaded on every reboot you can also add it or into /etc/modules.conf (on RHEL: echo 'modprobe tun' >> /etc/sysconfig/modules/tun.modules) or into /etc/sysconfig/vz-scripts/''VEID''.mount. (echo 'modprobe tun' >> /etc/sysconfig/vz-scripts/''VEID''.mount)
  
 
== Granting container an access to TUN/TAP ==
 
== Granting container an access to TUN/TAP ==

Revision as of 12:42, 30 September 2009

This article describes how to use VPN via the TUN/TAP device inside a container.

Kernel TUN/TAP support

OpenVZ supports VPN inside a container via kernel TUN/TAP module and device. To allow container #101 to use the TUN/TAP device the following should be done:

Make sure the tun module has been already loaded on the hardware node:

# lsmod | grep tun

If it is not there, use the following command to load tun module:

# modprobe tun

To make sure that tun module will be automatically loaded on every reboot you can also add it or into /etc/modules.conf (on RHEL: echo 'modprobe tun' >> /etc/sysconfig/modules/tun.modules) or into /etc/sysconfig/vz-scripts/VEID.mount. (echo 'modprobe tun' >> /etc/sysconfig/vz-scripts/VEID.mount)

Granting container an access to TUN/TAP

Allow your container to use the tun/tap device by running the following commands on the host node:

vzctl set 101 --devices c:10:200:rw --save
vzctl set 101 --capability net_admin:on --save

And create the character device file inside the container (execute the following on the host node):

vzctl exec 101 mkdir -p /dev/net
vzctl exec 101 mknod /dev/net/tun c 10 200
vzctl exec 101 chmod 600 /dev/net/tun

Configuring VPN inside container

After the configuration steps above are done it is possible to use VPN software working with TUN/TAP inside container just like on a usual standalone linux box.

The following software can be used for VPN with TUN/TAP:

Troubleshooting

If NAT is needed within the VE, this error will occur on attempts to use NAT:

# iptables -t nat -A POSTROUTING -s 10.8.0.0/24 -o venet0 -j MASQUERADE
iptables v1.4.3.2: can't initialize iptables table `nat': Table does not exist (do you need to insmod?)
Perhaps iptables or your kernel needs to be upgraded.

The solution is given here:

http://kb.parallels.com/en/5228

Also see page 69-70 of:

http://download.openvz.org/doc/OpenVZ-Users-Guide.pdf

Note that the above steps do not solve the problem if a gentoo VE sits on a Centos HN; it's still an unsolved mystery.

External links